Not a member yet? Why not Sign up today
Create an account  

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
I think I finally 'get' inline turbo's.... somewhat

#1
Wink 
Below is a recent attempt to make a pretty simplistic inline turbo engine. Don't ask what iteration of the prototype it is....

3H x 5W x Y long. Staggered flat rows of cylinders with a single carb each, exhaust piped along the bottom, wrapped around the end, and then daisy chained back through the individual turbo's one at a time.

Notes:

1) There's a gap in the bottom middle that's totally empty. That indicates to me there might be a better pattern?

2) Much in the same vein, I basically stuck Superchargers into gaps wherever they fit and stayed within the 3 x 5 dimensions, starting with the spots where more then one carb could make use of them. I know that Super's aren't THAT amazing, except at low RPM, but it's what I could fit.

All thoughts and constructive feedback/criticism welcome.

Stats, as requested: 1000 overall power.
At 100% rpm, it's getting 382 power per fuel (2.6 per second).
at 50% rpm, it's getting 450 PPF, consuming 1.1 fuel per second.
at 10% RPM, it goes to 492 PPF, at 0.2 per second fuel used


Attached Files Thumbnail(s)
           

.blueprint   simple inline turbo engine.blueprint (Size: 59.88 KB / Downloads: 8)
.blueprint   simple inline modded by killshoot.blueprint (Size: 60.19 KB / Downloads: 5)
********************************
(Is in your ship, stealing your turrets!)

Mods/extra blocks

After Cataclysm (and the separate 'railings' mod as well)
Dynamic Kinetics Simple Re-skin (armored glass)
Wrought Iron Armor
Structural Foam
Aero-alloy
More Corners 0.3
Reply



Messages In This Thread
I think I finally 'get' inline turbo's.... somewhat - by Greyfell - 2018-07-09, 04:22 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)